Aggregates & Rocks

Polishing & Skid Resistance
TG-207 – Accelerated Polishing Machine
Polished stone value
Fourteen specimens clamp around the flat rim of the road wheel to form a continuous stone surface 45 mm wide and 405 mm in diameter. The road wheel turns at 320 to 325 rpm.
A rubber-tyred wheel, 200 mm in diameter and 50 mm wide, presses on the stone surface with a total load of 40 kg. It turns freely on an axis parallel to the road wheel and runs exactly in line with it. The tyre is a smooth 8 × 2 pneumatic 4-ply hand-truck tyre of hardness 55 ± 5, inflated to 3.15 ± 0.15 kg/cm².
Separate feeds spread sand and water (about 12 g/min of sand and 20 g/min of water) or emery powder and water (about 2 g/min of emery and 5 g/min of water) evenly where the tyre meets the specimens.
A new tyre needs a 3-hour run-in with sand and 3 hours with emery on spare specimens before use, and should be replaced after 30 test runs or sooner if it wears unevenly. The machine must be bolted to a firm, level base of stone or concrete.
Supplied ready for use with operating manual and test certificate. Contact us for configuration options, accessories and calibration services.
Technical specifications
| Specimens per run | 14 |
|---|---|
| Stone surface | 45 mm wide, 405 mm dia |
| Road wheel speed | 320–325 rpm |
| Tyre | 200 × 50 mm, 8 × 2 pneumatic 4-ply |
| Tyre load | 40 kg |
| Tyre pressure | 3.15 ± 0.15 kg/cm² |
| Sand feed | ~12 g/min sand + 20 g/min water |
| Emery feed | ~2 g/min emery + 5 g/min water |
Request information
Tell us about your requirements and we will get back to you.



